Mitsubishi MELSEC L Series User Manual page 92

(2) Operation on the connected device (FTP client) side
The following describes the procedure and processing on the connected device side, which is required for using
the FTP server function of the CPU module.
Various FTP commands and how to enter each of them are also shown.
(<ret> indicates an input of the CR, Enter, or Return key.)
Start
Start the FTP client.
Login to the CPU module
Is remote
password enabled
for FTP?
YES
Unlock the remote
password.
Is file transfer
completed?
NO
Write files
to the FTP server?
NO
File reading
No file conversion is notified.
Check the file list.
NO
Does the read
target file exist?
YES
Is File
NO
password 32 set for the
target file?
YES
Enter a file password.
Read the file.
90
(ftp <ret>)
(open "CPU module's IP address" <ret>)
NO
(quote password-unlock
"remote password" <ret>)
YES
YES
(binary <ret>) No file conversion is notified.
(dir <ret>
Check the file list.
or ls <ret>)
NO
Does the write
target file exist?
Can it be overwritten?
(quote passwd-rd
NO
"read password" <ret>)
password 32 set for the
(get "file name" <ret>)
Enter a file password.
Delete or rename the file.
Write the file.
File writing
(binary <ret>)
(dir <ret> or
ls <ret>)
YES
NO
YES
Is File
target file?
YES
(quote passwd-wr
"write password" <ret>)
(delete "file name" <ret> or
rename "current file name"
"new file name" <ret>)
(put "file name" <ret>)
NO
Is remote
password enabled
for FTP?
YES
(quote password-lock
Lock the remote password.
<ret>)
Disconnect from
(bye <ret>)
the CPU module.
End