JVC NX-MD1R Service Manual page 28

NX-MD1R/NX-MD1
Removing the feed motor assembly
It is not necessary to remove the pickup unit.
1. For the white and black harnesses extending from
the feed motor assembly, unsolder the soldering i
on the traverse mechanism board.
2. Remove the two screws M attaching the feed motor
assembly.
3. Remove the two screws P attaching the feed motor
bracket.
Removing the
board (See Fig.19)
Prior to performing procedure, remove the feed
motor assembly.
1. For the red and black harnesses extending from the
spindle motor, unsolder the soldering j on the
traverse mechanism board.
2. Remove the screw N
mechanism board.
1-28
(See Fig.19, 20)
traverse mechanism
attaching the traverse
Traberse mechanism board Soldering j
N
Soldering i
Feed motor assembly
M
Fig.19
Feed motor
Feed motor bracket
P
Fig.20