JVC NX-MD1R Service Manual page 11

Removing the CD mechanism
assembly
Prior to performing the following procedure, remove
the top cover.
Prior to performing the following procedure, remove
the rear cover.
Prior to performing the following procedure, remove
the system control board.
Prior to performing the following procedure, remove
the main amplifier board.
Prior to performing the following procedure, remove
the AC jack board.
Prior to performing the following procedure, remove
the MD mechanism assembly.
1. Remove the four screws U attaching the sub
chassis from the left and right side of the bottom
chassis.
Remove the screw V attaching the sub chassis.
2. Disconnect the card wire from connector CN691 on
the repeater board.
3. Remove sub chassis cover with regulator board
and fan motor assembly in the direction of the
arrow.
4. Remove the three screws W attaching the CD
mechanism assembly.
5. Disconnect the card wire from connector CN606 on
the CD servo board.
6. Remove the CD mechanism assembly while lifting
the rear part of it.
(See Fig.13 and 14)
CN691
U
CN606
Sub chassis
U
Fig.13
W
CD mechanism
assembly
W
Fig.14
NX-MD1R/NX-MD1
Fun motor assembly
Regulator
board
V
W
1-11