JVC NX-MD1R Service Manual page 13

<Front panel assembly section>
Prior to performing the following procedure, remove
the front panel assembly.
Removing the front board (See Fig.16)
1. Remove the two screws Y attaching the MD
bracket.
2. Remove the MD bracket.
(Caution) When assembling, fit the rib of the front
panel into the location hole g on the MD
bracket before attaching it.
3. Remove the eight screws Z attaching the front
board.
4. Remove the front board.
(Caution) When assembling, fit the rib of the front
panel into the location hole h on the
front board before attaching it.
Removing head phone & USB board
1. Remove the wire from two wire holders i.
2. Remove the two screws AA attaching the head
phone & USB board.
3. Remove the head phone & USB board.
MD bracket
Location hole g
Location hole h
(See Fig.16)
Z
Y
Z
Z
AA
Head phone & USB board
Fig.16
NX-MD1R/NX-MD1
Location hole g
Front board
Location hole h
Wire holder i
Wire holder i
1-13