NX-MD1R/NX-MD1
Removing the Loading assembly
Ref:
The loading assembly, the traverse mechanism
assembly and the single flame will be
removable after removing the loading assembly
from the body.
Prior to performing the following procedure, remove
the MD servo board, the mechanism cover, the head
lifter and the head assembly.
1.
Remove the two screws D and screw D' on the
upper side of the body.
2.
Move the loading assembly forward to disengage it
from the traverse mechanism assembly (Joint d).
Then remove it upward.
3.
Remove the traverse mechanism assembly from the
single flame.
1-24
(See Fig.8 and 9)
D
Joint d
Fig.8
Fig.9
D
Loading assembly
Earth wire
D'
Loading assembly
Traverse mechanism
assembly
Single flame