JVC NX-MD1R Service Manual page 27

<Traverse mechanism assembly section>
Removing the Insulators (See Fig.16)
1. Disengage the four insulators from the notches of the
traverse mechanism chassis.
Removing the pickup unit (See Fig.17)
1. Turn over the traverse mechanism assembly and
remove the screw K attaching the shaft holder (F).
2. Move the shaft inward and remove it from the shaft
holder (R).
3. Detach the shaft side of the pickup unit upward and
release the joint h with the pickup guide. Then
remove the pickup unit with the shaft.
Removing the pickup (See Fig.18)
1. Draw out the shaft from the pickup.
2. Remove the two screws L attaching the rack spring.
Pickup unit
Insulators
Traverse machanism chassis
Fig.16
Joint h
Shaft holder (F)
K
Fig.17
L
Rack spring
Fig.18
NX-MD1R/NX-MD1
Insulators
Pickup guide
Pickup unit
Shaft holder (R)
Pickup
Shaft
1-27