NX-MD1R/NX-MD1
<MD mechanism assembly section>
Prior to performing the following procedure, remove
the top cover.
Prior to performing the following procedure, remove
the rear cover.
Prior to performing the following procedure, remove
the MD mechanism assembly.
Removing the MD mechanism
assembly
1.
Remove the screw AB attaching the earth plate
board.
2.
Remove the card wire on the MD mechanism
assembly.
3.
Disconnect the card wire from connector CN522 on
the MD servo board, then remove it.
4.
Remove the four screws AC attaching the MD
bracket from left and right side of the MD
mechanism assembly.
5.
Remove the MD bracket to the bottom side.
1-14
(See Fig.17)
Card wire
Earth plate board
AB
AC
CN522
MD bracket
Fig.17
AC
Card wire