Building In - Zanussi ZWT 71401 WA User Manual

Building in

Overview
This appliance has been designed to be built
into the kitchen furniture. The recess should
have the dimensions shown in Fig. 1.
Fig. 1
600 mm
min.
596 mm
560 mm
min.
820 mm
75 mm
60 mm
Preparation and assembly of the door
The appliance is originally prearranged for the
assembly of a door opening from right to left
(Fig. 2).
Fig. 2
www.zanussi.com
555 mm
818 mm
170 mm
100 mm
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90
cm. The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside di-
ameter of the drain hose. The drain hose must
not be kinked.
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height X depends on the height of the ad-
jacent furniture's base (Fig. 3).
Fig. 3
16-22 mm
Ø 35 mm
14 mm
b) Hinges
To mount the hinges it is necessary to drill two
holes (dia. 35 mm, depth 12.5-14 mm depend-
ing on the depth of door furniture) on the inner
side of the door. The distance between the
holes hobs fixing centres must be 416 mm.
The distance from upper edge of the door to
the centre of the hole depends on the adjacent
furniture's dimensions.
The hinges will be fixed to the door by means of
screws for wood 1 and 2 (Fig. 4) supplied with
the appliance.
X
416
mm
22±1,5 mm
595-598 mm
27