What To Do If - Zanussi ZWT 71401 WA User Manual

Hide thumbs Also See for ZWT 71401 WA:
Table of Contents

Advertisement

Available languages

Available languages

• if necessary, wait until the water has cooled
down;
• open the pump door;
• place a bowl on the floor and place the end
of the emergency emptying hose into the
bowl. Remove its cap. The water should
drain by gravity into the bowl. When the bowl
is full, put the cap back on the hose. Empty
the bowl. Repeat the procedure until water
stops flowing out;
• clean the pump if necessary as previously
described;

What to do if...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
red pilot light of button 8 blinks, one of the fol-
lowing alarm codes appears on the display and
some acoustic signals sound every 20 seconds
to indicate that the machine is not working:
Problem
The washing machine does
not start:
www.zanussi.com
• replace the emergency emptying hose in its
• screw the pump cover again and close the
Important! Every time you drain the water
through the emergency emptying hose you
must pour 2 litres of water into the main wash
compartment of the detergent drawer and then
run the drain programme. This will activate the
ECO Valve device avoiding that part of the
detergent remains unused at next washing.
Once the problem has been eliminated, press
the button 8 to restart the programme. If after
all checks, the problem persists, contact your
local Service Centre.
Possible cause/Solution
The door has not been closed. E40
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 8 has not
been pressed.
• Please turn the selector dial and press the button 8 again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel the delay start.
The Child Safety Lock has been activated.
• Deactivate the Child Safety Lock.
seat after having plugged it;
door.
: problem with the water supply.
: problem with the water draining.
: door open.
21

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents