Zanussi ZWT 71401 WA User Manual page 26

Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in the floor.
After having levelled the appliance, tighten the
lock nuts.
Water inlet
Caution!
• This appliance must be connected
to a cold water supply.
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected.
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
26
Any necessary ad-
justment can be
made with a spanner.
45°
Open the porthole and extract the inlet hose.
Connect the appropriate end of the hose to
the appliance with the angled connection as
showed in the picture. Do not place the in-
let hose downwards. Angle the hose to the
left or right depending on the position of your
water tap.
After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks .
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
Connect the other
end of the inlet hose
to a tap with a 3/4"
thread. Always use
the hose supplied
with the appliance.
Hooked over the
edge of a sink us-
ing the plastic
hose guide.
www.zanussi.com