Building In - Zanussi ZWT 71401 WA User Manual

Important! Before connecting up the machine to new
pipework or to pipework that has not been used for some
time, run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
Water drainage
The end of the drain hose can be positioned in three ways.
• Hooked over the edge of a sink using the plastic hose
guide supplied with the machine. In this case, make
sure the end cannot come unhooked when the machine
is emptying. This could be done by tying it to the tap
with a piece of string or attaching it to the wall.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available
from your local Service Centre.

Building in

This appliance has been designed to be built into the
kitchen furniture. The recess should have the dimensions
shown in picture A.
www.zanussi.com
• In a sink drain pipe branch. This branch must be above
the trap so that the bend is at least 60 cm above the
ground.
• Directly into a drain pipe at a height of not less than 60
cm and not more than 90 cm. The end of the drain
hose must always be ventilated, i.e. the inside diameter
of the drain pipe must be larger than the outside diam-
eter of the drain hose. The drain hose must not be
kinked.
25