Building In - Zanussi ZWT 71201 WA User Manual

If your drain hose looks
like this (see beside) you
do not require the "U"
piece". Just push the hose
firmly in to the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not
been used before, remove
any blanking plug that
may be in place.

Building in

This appliance has been designed to be built into the
kitchen furniture. The recess should have the dimensions
shown in picture A.
24
Loop
Push the drain hose onto
the spigot and secure with
a clip, ensure a loop is
formed in the drain hose
(see above) to prevent
waste from the sink enter-
ing the appliance.
If you intend to drain the hose from the machine into a
sink, make sure that the sink is empty and the plug hole
is not blocked. Use the plastic "U - Piece" supplied.
In the interest of the environment
The appliance should be connected to the FOUL drainage
system, the water will then be taken to a sewage works for
treatment before being discharged safely into a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is dis-
charged directly into a river or stream and may cause pol-
lution.
If you require any further advice please contact your local
water authority.
SHOWER
BATH
WASHING
MACHINE
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
SINK TOILET
BIDET
DISHWASHER
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
TREATED DISCHARGE
RIVER
www.zanussi.com