Mounting The Hub To A Mounting Frame - Extron electronics USB HUB4 AAP User Manual

Wall Stud
Installation Cable
Cable Clamp
Screws or Nails
Figure 10. Attaching a Wall Box to a Wall Stud
To attach a wall box to wood, use four #8 or #10 screws or 10-penny nails. A
•
minimum of 1/2 inch (1.3 cm) of screw threads must penetrate the wood.
To attach a wall box to metal, use four #8 or #10 self-tapping sheet metal screws or
•
machine bolts with matching nuts.
If using a mounting bracket, follow the directions included with the bracket to attach
•
the clips that fasten the bracket to the wall or furniture.
NOTE: Cable and test the HUB4 before mounting it to the wall box, mounting
bracket, or furniture.

Mounting the hub to a mounting frame

If the HUB4 is mounted to a wall box or mounting bracket, it must first be mounted into
an AAP or MAAP mounting frame, such as the Extron AAP 102 or CPM101 listed at
www.extron.com
.
Follow the steps below to mount the HUB4 into the appropriate size mounting frame.
USB HUB4 AAP:
1. Insert the four threaded studs on the back of the front panel through the holes in an
AAP mounting frame and seat the HUB4 in the two-gang opening of the frame.
2. Attach the provided hex nuts to the studs on the back side of the frame (see figure 11).
AAP 102 Mounting Frame
0 2
P 1
A A
Extron
USB HUB4 AAP
Figure 11. Mounting a USB HUB4 AAP to a Two-gang Mounting Frame
Wall Stud
Installation Cable
Cable Clamp
Screws or Nails
IT Y
T IV
A C
A P
4 A
U B
B H
U S
USB HUB4 Series • Installation 11