NordicTrack NTL14215.1 User Manual page 12

7. Slide the Right Inside Upright Cover (70) against
the lower end of the right Upright (83). Press
the Right Outside Upright Cover (71) against
the Right Inside Upright Cover until it snaps
into place. Make sure that the wires are not
pinched.
Attach the Left Inside Upright Cover and the
Left Outside Upright Cover (not shown) as
described above. Note: There is not a wire on
the left side.
8. Press the two tabs on the Tablet Holder (65) into
the slots (D) in the console assembly (B).
Attach the Tablet Holder (65) to the console
assembly (B) with four #8 x 5/8" Machine Screws
(8). Tip: Start the two top Machine Screws
fi rst, and then start the two bottom Machine
Screws. Be careful not to overtighten the
Machine Screws.
IMPORTANT: The Tablet Holder (65) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
7
70
8
Start First
8
12
83
Wires
71
65
D
B