Ricoh SP 8400DN User Manual page 90

3. Troubleshooting
Problem
Edges of sheets are creased. You are using non-
Duplex printing cannot be
applied.
Duplex printing cannot be
applied.
Duplex printing cannot be
applied.
White stripes appear on the
OHP transparency.
Other printing problems
Problem
It takes a long time to
complete a print job.
88
Cause
recommended paper.
You have loaded paper that
is too thick or thin.
You have selected a paper
tray that is not set for duplex
printing.
You have selected a paper
type that cannot be used for
duplex printing.
Fragments of paper are
stuck to the OHP
transparency.
Cause
Sleep mode or Fusing Unit
Off mode might be set.
Solution
Use recommended paper. For details
about recommended paper, see
page 51 "Recommended Paper Sizes
and Types".
Change the paper. For details about
paper weight that can be used for
duplex printing, see "Specifications for
the Main Unit", Operating Instructions.
Change the setting for "Apply Duplex"
in "Tray Paper Settings" to enable
duplex printing for the paper tray. For
details about setting "Apply Duplex",
see "Tray Paper Settings", Operating
Instructions.
In "Tray Paper Settings", select a paper
type that can be used for duplex
printing. For details about setting
"Paper Type", see "Tray Paper
Settings", Operating Instructions.
Use a dry cloth to wipe any paper
fragments off the back of the OHP
transparency.
Solution
The machine requires time to warm up
if it has been in Sleep mode or Fusing
Unit Off mode. For details about Sleep
mode and Fusing Unit Off mode, see
page 31 "Saving Energy".