Ricoh SP 8400DN User Manual page 72

3. Troubleshooting
Problem
Misfeeds occur frequently.
Misfeeds occur frequently.
Misfeeds occur frequently.
70
Cause
Using curled paper often
causes misfeeds, soiled
paper edges, or slipped
positions while stack printing
is performed.
The tray's side or end fences
may not be set properly.
Paper of undetectable size
has been loaded.
Solution
• Flatten the paper with your hands
to straighten out the curl.
• Load the paper upside down so
that the curled edges face
downward. For details about
recommended paper, see
page 51 "Recommended Paper".
• Place the cut paper on a flat
surface to prevent it from curling,
and do not lean it against the
wall. For details about the proper
way to store paper, see "Paper
Storage", Operating Instructions.
• Remove the misfed paper. For
details about removing jammed
paper, see page 92 "Removing
Jammed Paper".
• Check that the side or end fences
are set properly. Also, check that
the side fences are locked. For
details about setting the side and
end fences, see "Changing the
Paper Size", Operating
Instructions.
• Remove misfed paper. For details
about removing jammed paper,
see page 92 "Removing
Jammed Paper".
• If you load a paper size that is not
selected automatically, you need
to specify the paper size with the
control panel. For details about
specifying paper size with the
control panel, see "Changing to a
Size That Is Not Automatically
Detected", Operating Instructions.