THOMSON TG185n Setup And User Manual page 66

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE: Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users
must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with
be installed and operated with minimum distance 20cm between the radiator & your body. End users must follow the specific
FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual.
operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
requirements, please follow operation instruction as documented in this manual. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. The availability of some specific hannels and/or operational The availability of some specific channels and/or operational frequency bands are country dependent and are
firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the
frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The
end user.
firmware setting is not accessible by the end user.
Restricted Frequency Band
In case this product is equipped with a wireless transceiver, it may only use channels 1 to 11 (2412 to 2462 MHz) on
U.S.A. territory.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only.
6