Rn Series Startup Form - AAON RN SERIES Installation Operation & Maintenance

Date:______________
Job Name:_____________________________________________________________________
Address:______________________________________________________________________
______________________________________________________________________________
Model Number:_________________________________________________________________
Serial Number:____________________________________________
Startup Contractor:______________________________________________________________
Address:_________________________________________________
________________________________________________________
Pre Startup Checklist
1. Is there any visible shipping damage?
2. Is the unit level?
3. Are the unit clearances adequate for service and operation?
4. Do all access doors open freely and are the handles operational?
5. Have all electrical connections been tested for tightness?
6. Does the electrical service correspond to the unit nameplate?
7. On 208/230V units, has transformer tap been checked?
8. Has overcurrent protection been installed to match the unit nameplate
requirement?
9. Have all set screws on the fans been tightened?
10. Do all fans rotate freely?
11. Is all copper tubing isolated so that it does not rub?
12. Has outside air rain hood been opened?
13. Have the damper assemblies been inspected?
14. Are the air filters installed with proper orientation?
15. Have condensate drain and p-trap been connected?
Supply Fan Assembly
Alignment
Number hp
1
2
Band Size_____________________
VFD Frequency________________
96

RN Series Startup Form

Installing contractor should verify the following items.
Check Rotation
L1
Nameplate Amps________
L2
VAV Controls_________________
Tag:_______________
Phone:_____________
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
L3