Setting Up Plc Communications - Omron NV Series Programming Manual

Creating a Simple Screen
4-2-8

Setting Up PLC Communications

1,2,3...
The communications settings must be changed in the PLC so that it can com-
municate with the PT. In this section, an NV3Q PT and a CP-series PLC are
used as an example.
CX-Programmer
Set and transfer the PLC Setup.
Commercially available
USB cable
1. Start the CX-Programmer.
2. Make the following settings on the Serial Port 1 Tab Page for the CP1E and
the Serial Port Tab Page for other PLCs in the PLC Setup.
Communications setting: User settings
Baud rate:
Parameters:
Host link No.:
3. Transfer the PLC Setup from the CX-Programmer to the PLC.
PLC
9,600 bps
7, 1, E
0
Section 4-2
51