Siemens SIMATIC ET 200SP Manual page 47

Parameter
Reference speed [10 rpm]
3 -2
Potential group
This parameter cannot be configured using PROFIBUS GSD file. The parameter is loaded to the module with the de-
1
fault setting and can be adapted using the data record 128.
When a GSD file is used, this diagnostic interrupt is activated via the "Enable additional diagnostic interrupts" parameter
2
and cannot be set separately.
Only available in "Position input for Motion Control" operating mode
3
Only available in "Fast Mode" operating mode
4
Technology module TM PosInput 1 (6ES7138-6BA00-0BA0)
Manual, 04/2016, A5E33015755-AC
Value range
600...21000000
Use the potential group of the left
•
module (dark BaseUnit)
Enable new potential group (light
•
BaseUnit)
Configuring/address space
Default setting
300000 (corresponds to
3000 rpm)
Use the potential group of
the left module (dark Ba-
seUnit)
4.4 Parameters
Re-
configuration
in RUN
Yes
No
47