Example 4 - Using The Setpoint Programmer Aux Output - Honeywell UMC800 Reference Manual

Function Blocks
2.60 SPP Function Block,

2.60.4 Example 4 - Using the Setpoint Programmer AUX Output

The Auxiliary output of the Set Point Programmer (SPP)
block can be used to drive the RSP of a secondary PID
control block on a level basis. This precludes the use of
another SPP block. A different (or same) set point can be
configured for each programmer step. This can be used to
program pressure, %C, etc. for a second control loop.
1800
Deg. F
0
10
Atm
2.6
1
Figure 2-66 Using the Setpoint Programmer AUX Output
188
continued
TEMP
Time
Pressure
5.0
3.75
Time
Function Block Reference Guide
FAIL FAIL
3/99