Sps Function Block - Honeywell UMC800 Reference Manual

Function Blocks

2.61 SPS Function Block

Description
The SPS label stands for Master Setpoint Scheduler. This block is part of the Setpoint Scheduler
category. It looks like this graphically on the Control Builder.
Overview
The objective of the Setpoint scheduler is to provide a sequence of multiple setpoint outputs (both analog
and digital) which are referenced to a common time base. Five setpoint schedule block types will be
implemented:
• Master Setpoint Scheduler Block (SPS – this section)
• Auxiliary Setpoint Block (SPSA –
• Digital Event Block (SPEV –
• State Switch Block (STSW –
• State Flags Block (STFL –
A suite of Setpoint Scheduler blocks is comprised of one master Setpoint Block (required) and optionally,
one Digital Event, one Auxiliary Setpoint, one State Switch, and/or one State Flags block.
Figure 2-68
See
190
Subsection
Subsection
Subsection
Subsection
for a Setpoint Scheduler Function Block Suite.
Function Block Reference Guide
2.62)
2.59)
2.65)
2.64)
Continued next page
3/99