Table 2-38 Pushbutton Function Group Configuration - Honeywell UMC800 Reference Manual

2.49 PB Function Block,
Configuration Procedure
Follow the procedure in Table 2-38 to configure the Pushbutton Function Groups.
•
There are four pushbuttons that can be configured for
each block.
You can assign just a label for the display using the Output
descriptor.
You can also select signal tags from the "Signal Tag List" if
you require a feedback signal to be shown on the pushbutton
display.
•
Enter the Group Title Text in the appropriate field.
The "Signal Tag List" field shows all the Signal Tags
that have been configured on the Function Block
Diagram. Select "All Signals", "Analog Signals", or
"Digital Signals".
•
To Add a Digital Signal tag to a Pushbutton
location:
Click on a signal tag in the list, then click on
"Insert/Replace". The selected Signal tag will be
placed in the next available position in the "Signal
Tags/Descriptors" field.
•
To Insert a Digital Signal tag to a Pushbutton
location:
Select a position in the "Signal Tags/Descriptors"
field., then click on INSERT. (You must click in the
first column of the Selected Signal Tag list to select
a row.) The selected Signal tag will be placed in the
position chosen, and other signal tags will move
down as required. You may only insert to the
occupied portion of the list. An attempt to insert to
any empty row will place the new item in the first
empty row.
3/99
continued

Table 2-38 Pushbutton Function Group Configuration

Function Block Reference Guide
Function Blocks
Continued next page
135