HP 3600 v2 Series Configuration Manual page 218

[SwitchA-Ethernet1/0/3] undo lldp enable
[SwitchA-Ethernet1/0/3] port service-loopback group 1
[SwitchA-Ethernet1/0/3] quit
# Create interface Tunnel 1.
[SwitchA] interface tunnel 1
# Specify an IPv4 address for interface Tunnel 1.
[SwitchA-Tunnel1] ip address 30.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode.
[SwitchA-Tunnel1] tunnel-protocol ipv4-ipv6
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 1.
[SwitchA-Tunnel1] source 2001::1:1
# Specify the IP address of VLAN-interface 101 on Switch B as the destination address of interface
Tunnel 1.
[SwitchA-Tunnel1] destination 2002::2:1
# Reference service loopback group 1 on the tunnel.
[SwitchA-Tunnel1] service-loopback-group 1
[SwitchA-Tunnel1] quit
# Configure a static route from Switch A through interface Tunnel 1 to Group 2.
[SwitchA] ip route-static 30.1.3.0 255.255.255.0 tunnel 1
Configure Switch B:
•
# Enable IPv6.
<SwitchB> system-view
[SwitchB] ipv6
# Specify an IPv4 address for VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ip address 30.1.3.1 255.255.255.0
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::2:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchB] service-loopback group 1 type tunnel
# Assign Ethernet 1/0/3 to service loopback group 1, and disable STP, NDP, and LLDP on the
interface.
[SwitchB] interface Ethernet 1/0/3
[SwitchB-Ethernet1/0/3] undo stp enable
[SwitchB-Ethernet1/0/3] undo ndp enable
[SwitchB-Ethernet1/0/3] undo lldp enable
[SwitchB-Ethernet1/0/3] port service-loopback group 1
[SwitchB-Ethernet1/0/3] quit
# Create interface Tunnel 2.
[SwitchB] interface tunnel 2
# Specify an IPv4 address for interface Tunnel 2.
[SwitchB-Tunnel2] ip address 30.1.2.2 255.255.255.0
207