HP 3600 v2 Series Configuration Manual page 215

Description: Tunnel1 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2.1.1.1(Vlan-interface101), destination 3.1.1.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
4 packets input,
0 input error
12 packets output,
0 output error
[SwitchB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 3.1.1.1(Vlan-interface101), destination 2.1.1.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
5 packets input,
0 input error
9 packets output,
0 output error
# Ping the IPv4 address of the peer interface VLAN-interface 100 from Switch A.
[SwitchA] ping 10.1.3.1
PING 10.1.3.1: 56
Reply from 10.1.3.1: bytes=56 Sequence=1 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 10.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=4 ttl=255 time=16 ms
Reply from 10.1.3.1: bytes=56 Sequence=5 ttl=255 time=15 ms
--- 10.1.3.1 ping statistics ---
Never
0 bytes/sec, 0 packets/sec
2 bytes/sec, 0 packets/sec
256 bytes
768 bytes
Never
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
320 bytes
576 bytes
data bytes, press CTRL_C to break
204
0/100/0
0/500/0
0/75/0
0/100/0
0/500/0
0/75/0