HP 3600 v2 Series Configuration Manual page 20

Add Ethernet 1/0/2 and Ethernet 1/0/3 into VLAN 1, and specify IP address 16.1.1.30/24 for
•
VLAN-interface 1.
Add Ethernet 1/0/1 and Ethernet 1/0/4 into VLAN 2, and specify IP address 17.1.1.1/24 for
•
VLAN-interface 2.
• Specify 17.1.1.1/24 as the default gateway of Host A and Host B.
Specify 16.1.1.30/24 as the default gateway of Server A and Server B.
•
Disable the ARP entry check function so that the switch can learn dynamic ARP entries containing
•
multicast MAC addresses.
Configure a static multicast MAC address entry so that only interfaces Ethernet 1/0/2 and Ethernet
•
1/0/3 can receive multicast information.
Figure 5 Network diagram
Configuration procedure
This example only describes multicast ARP configuration on the switch, and is only applicable to multicast
NLB. For NLB configuration on the servers, see the related documents of the Windows Server.
# Specify an IP address for VLAN-interface 2.
<Switch> system-view
[Switch] vlan 2
[Switch-vlan2] port Ethernet 1/0/4
[Switch-vlan2] port Ethernet 1/0/1
[Switch-vlan2] quit
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] ip address 17.1.1.1 255.255.255.0
[Switch-Vlan-interface2] quit
# Specify an IP address for VLAN-interface 1.
[Switch] interface vlan-interface 1
[Switch-Vlan-interface1] ip address 16.1.1.30 255.255.255.0
[Switch-Vlan-interface1] quit
# Disable the ARP entry check function.
[Switch] undo arp check enable
# Configure a static multicast MAC address entry.
[Switch] mac-address multicast 03bf-1001-0164 interface Ethernet 1/0/2 Ethernet 1/0/3 vlan
1
9