HP 3600 v2 Series Configuration Manual page 213

Figure 90 Network diagram
Configuration procedure
Before configuring an IPv4 over IPv4 tunnel, make sure Switch A and Switch B have the corresponding
VLAN interfaces created and are reachable to each other.
Configure Switch A:
•
# Specify an IPv4 address for VLAN-interface 100.
<SwitchA> system-view
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ip address 10.1.1.1 255.255.255.0
[SwitchA-Vlan-interface100] quit
# Specify an IPv4 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ip address 2.1.1.1 255.255.255.0
[SwitchA-Vlan-interface101] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchA] service-loopback group 1 type tunnel
# Assign Ethernet 1/0/3 to service loopback group 1, and disable STP, NDP, and LLDP on the
interface.
[SwitchA] interface Ethernet 1/0/3
[SwitchA-Ethernet1/0/3] undo stp enable
[SwitchA-Ethernet1/0/3] undo ndp enable
[SwitchA-Ethernet1/0/3] undo lldp enable
[SwitchA-Ethernet1/0/3] port service-loopback group 1
[SwitchA-Ethernet1/0/3] quit
# Create interface Tunnel 1.
[SwitchA] interface tunnel 1
# Specify an IPv4 address for interface Tunnel 1.
[SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0
# Configure the tunnel encapsulation mode.
[SwitchA-Tunnel1] tunnel-protocol ipv4-ipv4
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 1.
[SwitchA-Tunnel1] source 2.1.1.1
# Specify the IP address of VLAN-interface 101 on Switch B as the destination address for interface
Tunnel 1.
[SwitchA-Tunnel1] destination 3.1.1.1
[SwitchA-Tunnel1] quit
# Reference service loopback group 1 on the tunnel.
202