Citizen CT-D150 Command Reference Manual page 229

CT-S280
Support
model
CT-S281
CT-D151/E651
CT-P29x series
• Setting MSW 1 (a=1)
n b (Set Value)
48 (Default) Reports the power on.
1
49 Does not report power on.
48 (Default) Sets input buffer capacity to 4K bytes.
2
49 Sets input buffer capacity to 45 bytes. (Note)
48 (Default) Sets input buffer full and offline to be Busy.
3
49 Sets to be busy with input buffer full.
At the occurrence of receiving error, replaces the data with
48 (Default)
4 "?".
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserved
• Setting MSW 2 (a=2)
n b (Set Value)
1 49 (Default) Reserved
48 Disables auto cutter.
2
49(Default) Enables auto cutter.
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After head-down* and PE recovery, prints as it is.
After head-down* and PE recovery, prints from the
5
49 beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
48 Sets paper width to 80 mm.
6
49 Sets paper width to 58(60) mm.
7 48 (Default) Reserved
8 48 Enables PNE.
CT-S300 CT-S2000 CT-S4000
CT-S310 CT-S801/851 CT-S601/651
Function
Function
CT-S251 CT-D150/E351
CT-P29x series CT-S310II
49 (Default) Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value)
48 (Default) After clearing cutter error, can be restored by Feed SW.
1
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
48 (Default) Resets with parallel pin 31.
3
49 Does not reset with parallel pin 31.
48 (Default) Uses thermal paper.
4
49 Uses Black mark paper.
48(Default) Used with 48 print columns
5
49 Used with 32 print columns.
6 48 (Default) Reserved
48 (Default) Sets EPSON compatible mode.
7
49 Sets CBM1000-compatible mode.
Sets
48 (Default)
error.
8
Sets
49
error.
- 228 -
Function
platen-open
error during printing to be auto recovery
platen-open
error during printing to be recoverable