Fs S N1 N2 - Citizen CT-D150 Command Reference Manual

Hide thumbs Also See for CT-D150:
Table of Contents

Advertisement

CT-S280
Support
model
CT-S281
CT-D151/E651

FS S n1 n2

[Function]
Setting Kanji space amount
[Code]
<1C>H<53>H<n1><n2>
[Range]
0≤n1≤255
0≤n2≤255
[Outline]
[The specification which is common to the model]
• Sets both right and left space amount of Kanji in units of dot.
• Sets left space amount by [n1×(Basic calculation pitch)] .
• Sets right space amount by [n2×(Basic calculation pitch)] .
[Caution]
[The specification which is common to the model]
• The right and left space amount in double-width mode are twice the setting.
• Setting independent line feed amount is possible in STANDARD MODE and PAGE MODE.
• Basic calculation pitch is set by GS P. Even if basic calculation pitch is changed by GS P after setting space
amount, there is no change in the amount of line feed.
When fractional number is caused by the calculation, it is corrected by the minimum pitch of mechanism and
the rest is discarded.
• In STANDARD MODE, basic calculation pitch (x) in horizontal direction is used.
• In PAGE MODE, the following operation occurs depending on the start point.
(1) When the start point is set at "upper left" or "lower right" by ESC T, basic calculation pitch (y) of vertical
direction (paper feed direction) is used.
(2) When the start point is set at "upper right" or "lower left" by ESC T, basic calculation pitch (x) of horizontal
direction (at right angle to paper feed direction)is used.
• The maximum right spacing is capable of approximately 31.906 mm (255/203 inches). A setting greater than
this maximum is trimmed to the maximum.
[Default]
n1=0, n2=0
[The specification which is common to the model]
CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II)
CT-D151/CT-E651
When MSW6-2=OFF: n1=n2=0
When MSW6-1=ON: n1=0, n2=2
CT-S300
CT-S2000
CT-S310
CT-S801/851
- 191 -
CT-S4000
CT-S251
CT-S601/651
CT-P29x series
/CT-S310II
/CT-S251/CT-D150/CT-E351/
CT-D150/E351
CT-S310II

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents