Replacing The Display Assembly; Procedure - Dell XPS 15 Service Manual
Hide thumbs
Also See for XPS 15:
- Quick start manual ,
- Setup manual (112 pages) ,
- Service manual (110 pages)
Table of Contents
Advertisement
Identifier
Status
Replacing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status
Procedure
1
Place the palm-rest assembly at the edge of the table with the speakers facing
away from the edge.
2
Align the screw holes on the palm-rest assembly with the screw holes on the
display hinges.
3
Replace the six screws (M2.5x5) that secure the display hinges to the palm-rest
assembly.
4
Adhere the tape and route the touch-screen cable (optional) through the routing
guides on the fan.
5
Connect the touch-screen cable and display cable to the system board.
NOTE: The touch-screen cable is available only on laptop configurations
with touch displays.
6
Replace the screw (M2x2) that secures the display-cable bracket to the system
board.
84
GUID-2DF70EB1-9D26-4051-8B7C-FB14A89925D8
Released
computer. After working inside your computer, follow
After working inside your
GUID-DA82B76C-0EE3-4263-9033-54BF36A6B5B6
Released
computer. For more safety best
www.dell.com/
Before
Advertisement
Table of Contents
