Invacare Rea Comfort Assembly Instructions Manual page 37

2.
B
E
Tools:
3.
A
B
Tools:
REA ASSIST
A
C
D
F
10 mm fi xed spanner
2.5 mm Allen Key
Screwdriver
Fitting the cable
The cable should be fitted from above, see page 39.
2. Feed the cable (A) through fitting (B), as shown
in the diagram. Feed it through fitting (C) and
then feed the end of the cable (D) into fitting (E).
Tighten nuts (F) against one another.
F
3. Run the cable up to the right-hand push handle.
Use an Allen key to secure fitting (A) in postion.
Use the two screws to secure the operating
handle (B) in position. Feed the cable into fitting
(C) on the backrest rail, so as to hold the cable
in place.
Tension the cable via the nuts next to the piston,
see diagram 1. There should be a minimal amount
of slack in the operating handle (B)
C
37