Yamaha XP530E-A Owner's Manual page 44

Instrument and control functions
Setting mode
1
2
3
1. Setting mode display
4
TIP

The vehicle must be stopped to
change settings in this mode.
5

Starting off or turning the vehicle
power off saves all settings made,
then exits the setting mode.
6
Push the "MENU" switch for 2 seconds
to enter the setting mode. To exit the
7
setting mode and return to the normal
display, push the "MENU" switch again
for at least 2 seconds.
8
Display
9
Grip Warmer
10
Seat heater
11
Traction Control
12
13
Maintenance
14
1
Description
This function allows you to
set the low, middle, and
high settings to 10
temperature levels.
This function allows you to
set the low, middle, and
high settings to 10
temperature levels.
This function allows you to
switch the traction control
system on or off.
This function allows you to
check and reset the "OIL"
oil change interval
(distance traveled), "V-
Belt" V-Belt change interval
(distance traveled), and
the "FREE" maintenance
intervals.
Unit
Display
Brightness
Clock
All Reset
TIP

Using the select switch "
switch the display items.

If grip warmer or seat heater is not
equipped, the "Grip Warmer" or
"Seat Heater" items will not ap-
pear.
Grip warmer settings
1. Use the select switch to highlight
"Grip Warmer".
5-11
This function allows you to
switch the fuel
consumption units can be
switched between
"L/100km" and "km/L".
For the UK: This function
does not indicate on
setting mode display.
This function allows you to
change the items shown in
3 information displays.
This function allows you to
adjust the brightness of the
speedometer, tachometer
and the multi-function
display panel to suit the
outside lighting conditions.
This function allows you to
set the clock.
This function allows you to
reset all items to factory
preset or default setting,
except the odometer,
clock, maintenance
counter item "Oil" and
maintenance counter item
"V-Belt".
/ " to