Yamaha XP530E-A Owner's Manual page 112

Scooter care and storage
structed. Also, thoroughly rinse
the area off with water, immedi-
ately dry it, and then apply a cor-
rosion protection spray.
1
Improper cleaning can damage

plastic parts (such as cowlings,
panels, windshields, headlight
2
lenses, meter lenses, etc.) and
the mufflers. Use only a soft,
clean cloth or sponge with wa-
3
ter to clean plastic. However, if
the plastic parts cannot be thor-
oughly cleaned with water, di-
4
luted mild detergent with water
may be used. Be sure to rinse
5 off any detergent residue using
plenty of water, as it is harmful
to plastic parts.
6
Do not use any harsh chemical

products on plastic parts. Be
sure to avoid using cloths or
7
sponges which have been in
contact with strong or abrasive
cleaning products, solvent or
8
thinner, fuel (gasoline), rust re-
movers or inhibitors, brake flu-
id, antifreeze or electrolyte.
9
Do not use high-pressure wash-

ers or steam-jet cleaners since
they cause water seepage and
10
deterioration in the following ar-
eas: seals (of wheel and swing-
11 arm bearings, fork and brakes),
electric components (couplers,
connectors,
12
switches and lights), breather
hoses and vents.
For scooters equipped with a

13
windshield: Do not use strong
cleaners or hard sponges as
they will
14
scratching. Some cleaning com-
instruments,
cause dulling
pounds for plastic may leave
scratches on the windshield.
Test the product on a small hid-
den part of the windshield to
make sure that it does not leave
any marks. If the windshield is
scratched, use a quality plastic
polishing
washing.
After normal use
Remove dirt with warm water, a mild
detergent, and a soft, clean sponge,
and then rinse thoroughly with clean
water. Use a toothbrush or bottlebrush
for hard-to-reach areas. Stubborn dirt
and insects will come off more easily if
the area is covered with a wet cloth for
a few minutes before cleaning.
After riding in the rain, near the sea or
on salt-sprayed roads
Since sea salt or salt sprayed on roads
during winter are extremely corrosive in
combination with water, carry out the
following steps after each ride in the
rain, near the sea or on salt-sprayed
roads.
TIP
Salt sprayed on roads in the winter may
remain well into spring.
1. Clean the scooter with cold water
and a mild detergent after the en-
gine has cooled down. NOTICE:
Do not use warm water since it
increases the corrosive action
of the salt.
2. Apply a corrosion protection spray
on all metal, including chrome- and
or
nickel-plated, surfaces to prevent
corrosion.
9-2
compound after
[ECA10792]