Operating Instructions; Cleaning Instructions - Wells H-33 Operation Installation Maintenance Manual
Hide thumbs
Also See for H-33:
- Owner's manual (25 pages) ,
- Operation manual (12 pages) ,
- Specifications (2 pages)
Advertisement
Installing Built-in Hotplates:
1.
Please refer to the backside of the specification sheet (General Layout Data) provided with this
manual for specific "cutout" dimensions and installation of the hotplate you have purchased.
2.
Install ele ctrical conduit (if required by local code) between hotplate and electrical box.
3.
Cut and/or drill holes as required in countertop apron.
4.
Mount unit and control panel.
OPERATING INSTRUCTIONS:
1.
Heat controls are equipped with an infinite switch for each cooking/heating element, allowing
adjustable temperature setting (OFF, LOW and HI) per element.
2.
Control light glows when the heat is turned ON, warning the operator to turn off the unit when not in
use.
3.
"High Speed" elements are super-sized, providing instant heat for extra-fast warming — cold to full
heat in 26 seconds.
Cooking Hints:
1.
Save energy costs by turning the unit off when not in use. Due to instant warm-up, it's not
necessary to le ave the unit on low heat during intermittent usage.
2.
Hotplates will hold up to 16 quart pots or pans.
3.
Hotplates with solid element, maximize heat efficiency by using flat bottom pots or pans.
CLEANING INSTRUCTIONS:
Before using your new hotplate, wipe entire unit clean using a clean, damp cloth/sponge with mild detergent
and towel dry.
1.
Turn temperature control knob to the OFF position.
2.
Allow unit to completely cool.
3.
Unplug hotplate (if countertop model).
4.
Wipe entire unit down using a clean cloth/sponge and a mild detergent.
WARNING:
5.
Wipe the stainless steel cabinet down with a damp cloth, this allows "lifetime" stainless steel to keep
its luster permanently.
IMPORTANT:
6.
To clean hotplates with swing-up elements, remove the heat reflector pans and clean with a damp
cloth and mild detergent, or place pans in a dishwasher.
DO NOT SUBMERGE HOTPLATE IN WATER (COUNTERTOP
UNITS). DO NOT SPLASH/POUR WATER ONTO THE CONTROL PANEL
OR WIRING. POSSIBLE SHOCK HAZARD MAY RESULT AND UNIT
MAY BE DAMAGED (COUNTERTOP AND BUILT-IN UNITS).
DO NOT USE STEEL WOOL FOR CLEANING.
7
Advertisement
