Appendix C Retrofitting The Gps And Ucm Board; Retrofitting The Gps Board - Motorola MTM800 User Manual

RETROFITTING the GPS and UCM BOARD
RETROFITTING the GPS and UCM BOARD
Retrofitting the UCM and GPS module should only be done by specially authorized and educated
Service Personnel. All operating and safety instructions are to be followed carefully.
Note: Refer to chapter 7 MAINTENANCE for dis-assembling and re-assembling the terminal prop-
erly.

Retrofitting the GPS board

1. Remove the metal blind cover from the bottom (5 screws, T10 TORX™).
2. Pull out the protection bushing.
3. Install the GPS board by starting with the connection of the flex to the mainboard.
4. Take care to fit the gasket of the coax cable in the right position for proper IP54 protection.
5. Fix the GPS board with one T10 TORX™ screw (1.13 Nm +/- 10% or 10 lbin +/- 10%).
6. Fix the GPS cover plate with five T10 TORX™ screws (1.13 Nm +/- 10% or 10 lbin +/- 10%).
Figure C-1 Position of GPS module at the terminal (view from bottom side)
Item No. Description
GPS Upgrade Kit
1 GPS Board (with flex and coax cable)
2 Screw (M3x8)
3 Label (not shown)
Table C-1
GPS Upgrade Kit
Parts List
Part Number
GMRG4219_
0166502N65
0310907A19
5466571B01
C - 1
APPENDIX C