Native Cypress System Format To Mo Disk; Setting An Ip Address - Siemens ACUSON Cypress Operator's Manual

Some viewers may experience problems reading long loops. The
DICOM
Cypress system can save loops that range in size from a single frame to the
maximum of 32 seconds. Select a loop size that is compatible to your
viewer.
The study cannot be converted from a
mat.

Native Cypress System Format to MO Disk

Studies can be exported in native Cypress system format to the
proprietary format stores images in a highly compressed, lossless format. Stud-
ies can be archived to the MO disk in this format to free up space on the internal
hard drive.
Restrictions:
Images stored in this format can only be opened for review on a Cypress sys-
tem. Once opened for review, the study can be exported to the
format or sent to a
DICOM
is installed).

Setting an IP Address

To set an IP address, follow these steps:
Press the key and click the Network Identification heading.
SETUP
1.
Click the [ ], [
ADD EDIT
2.
NOTE The Cypress system can store a maximum of four network
identifications
Complete the Cypress Network Identification settings described below:
3.
Network Name: User-defined name of the network. The Cypress system
can store a maximum of four network identifications.
Computer Name: Identifies the name of your Cypress system on the net-
work.
Workgroup Name: Identifies the workgroup your Cypress system is part
of.
IP Address (Internet Protocol Address): See your Network Administrator
to determine your IP address. An IP address is made up of four sets of
1—3 digit numbers (from 0 to 255), separated by periods.
Subnet Mask: See your Network Administrator to determine your Subnet
Mask. This number, combined with the IP address, identifies the network
that your computer is part of.
ACUSON Cypress™ Operator's Manual
Exporting Images from the Cypress System
DICOM
server over a network (if the network option
DICOM
], [ ], or [
REMOVE RENAME
format back to the Cypress for-
drive. This
MO
MO
] button.
DICOM
disk in
9-3