Displaying Device Information In Emergency Shell Mode; Emergency Shell Usage Example; Network Requirements; Usage Procedure - HP 5920 series Fundamentals Configuration Manual

Displaying device information in emergency shell
mode
Execute display commands in any view.
Task
Display copyright information.
Display software package information.
Display management Ethernet port information.
Display IPv4 routing information.
Display IPv6 routing information.
Display boot image version information.

Emergency shell usage example

Network requirements

The device has only the boot image (boot.bin) and enters emergency shell after startup. The device and
PC can reach each other.
Use the TFTP client service on the device to download system image system.bin from the PC and start the
Comware system on the device.
Figure 36 Network diagram

Usage procedure

# Check which files are stored and how much space is available on the storage medium of the device.
<boot>dir
Directory of flash:
0
1
2
3
.bin
4
5
6
-rw- 104833 Jan 01 2011 05:46:24
drw- - Jan 03 2011 03:33:27
-rw- 5341 Jan 01 2011 05:46:24
-rw- 9456640 Jan 03 2011 03:26:14
-rw- 3707 Jan 01 2011 01:26:51
drw- - Jan 01 2011 00:00:24
drw- - Jan 01 2011 00:00:24
Command
display copyright
display install package package
display interface m-eth0
display ip routing-table
display ipv6 routing-table
display version
startup.mdb
versionInfo
startup.cfg
5920-cmw710-boot-R2310
startup.cfg_bak
seclog
diagfile
135