Saving The Output From A Display Command To A File - HP 5920 series Fundamentals Configuration Manual

line class vty
user-role network-operator
#
line aux 0
user-role network-admin
#
line vty 0 63
authentication-mode scheme
user-role network-operator
#
ssh server enable
#
return
# Use | exclude Direct in the display ip routing-table command to filter out direct routes and display only
non-direct routes.
<Sysname> display ip routing-table | exclude Direct
Destinations : 12
Destination/Mask
2.2.2.0/24
# Use | include snmp in the display current-configuration command to filter in entries that contain snmp.
<Sysname> display current-configuration | include snmp
snmp-agent
snmp-agent community write private
snmp-agent community read public
snmp-agent sys-info version all
snmp-agent target-host trap address udp-domain 192.168.1.26 params securityname public

Saving the output from a display command to a file

A display command shows certain configuration and operation information of the device. Its output
might vary over time or with user configuration or operation. You can save the output to a file for future
retrieval or troubleshooting.
Use one of the following methods to save the output from a display command:
• Save the output to a separate file. Use this method if you want to use one file for a single display
command.
Append the output to the end of a file. Use this method if you want to use one file for multiple
•
display commands.
To save the output from a display command to a file, use one of the following commands in any view:
Task
Save the output from a display command to a separate file.
Append the output from a display command to the end of a file.
Routes : 12
Proto Pre Cost
OSPF 10 2
12
NextHop Interface
1.1.2.2 XGE1/0/2
Command
display command > filename
display command >> filename