Cam Head Balance - Citizen CL-E720DT Technical Manual

Chapter 3 Disassembly and Maintenance
3-6. Disassembly, Reassembly and Lubrication

(3) Cam Head Balance

1. Remove the "Spring Head L" (short) and "Spring Head R" (long).
2. Remove the "Cam Head Balance" as follows.
1) Set the "Cam Head Balance" (Media width adjustment dial) to "0"and remove the
"Lever Head Balance".
2) Remove the 1 screw (BH M3.0x6 (NI)), and detach the "Cam Head Balance" and "Pivot
Head Balance Cam".
3. Remove the 1 screw (BH M3.0x4 (NI)) and detach the "Holder Guide Sensor U".
4. Peel off the "Label Head Adjust", "Label Head Balance", "Label Heat Caution" and "Sheet
Head Holder" from the "SA Head Holder Base".
SA Head Holder Base
Sheet Head Holder
Notes on reassembling:
• Apply FLOIL G-311S to the following parts marked with

" ".
Pivot Head Balance Cam:
Cam Head Balance: Cam portion
• Once the label is peeled off, it cannot be reused.
• When attaching the "Sheet Head Holder", align its left
rear corner with the two marking lines on the "SA Head
Holder Base" as shown on the right.
CL-E720DT
Spring Head R
Lever Head Balance
Spring Head L
Surface
FLOIL G-311S
BH M3.0x6 (NI)
Pivot Head Balance Cam
Label Heat Caution
Label Head Balance
Label Head Adjust
SA Head Holder Base
3-32
Cam Head Balance
Holder Guide Sensor U
BH M3.0x4 (NI)
Sheet Head Holder