On-Line Configuration Programming - Sharp UP-3500 Instruction Manual

I I I I I On-line configuration programming
(1) Select the PGM2 mode and touch the [SETTING] to perform the programming.
(2) Touch the [ONLINE CONFIG] button to program details.
(3) Touch the required programming item, and enter or select each parameter and touch the [ENTER] key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text
TERMINAL No.
CI SIGNAL
LINE FORM
BAUD RATE
START CODE
END CODE
TIME OUT
AT OPEN STORE
AT CLOSE STORE
6 digits ((0 to 999999) : 000001)
SENSING: Sensing of the CI signal
NON: Non sensing of the CI signal
Transmission line form;
HALF: Half duplex system
FULL: Full duplex system
Transmission data rate (Baud rate)
115200 bps
57600 bps
38400 bps
19200 bps
9600 bps
4800 bps
2400 bps
Start code: 3 digits ((0 to 127) : 002)
End code: 3 digits ((0 to 127) : 013)
Time out time: 3 digits ((1 to 255 (sec)) : 007)
At command with open store: max. 50 characters (null)
At command with close store: max. 50 characters (null)
(ONLINE CONFIG ....... PGM2)
Parameter
289