C3850-Nm-8-10G Module - Cisco Catalyst 9300 Series Hardware Installation Manual

C3850-NM-8-10G Module

configure the last two ports as TenGigabitEthernet1/1/3 through TenGigabitEthernet1/1/4, even when you
are operating the last two ports as 1-G. Only four interfaces are valid, and the other four should not be used
even though they still show up in the CLI.
Table 23: C3850-NM-2-10G Module
Interface
GigabitEthernet1/1/1
GigabitEthernet1/1/2
GigabitEthernet1/1/3
GigabitEthernet1/1/4
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
C3850-NM-8-10G Module
All ports in the C3850-NM-8-10G module default to 10 G and should be configured as TenGigabitEthernet1/1/1
through TenGigabitEthernet1/1/8, even when you are operating them as 1 G using SFP.
Table 24: C3850-NM-8-10G Module
Interface
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
TenGigabitEthernet1/1/5
TenGigabitEthernet1/1/6
TenGigabitEthernet1/1/7
TenGigabitEthernet1/1/8
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
46
Action
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Disregard
Configure this interface, even when operating as 1-G
Configure this interface, even when operating as 1-G
Action
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Configure this interface
Installing a Network Module