Cisco Catalyst 9300 Series Hardware Installation Manual page 62

Installing SFP and SFP+ Modules
On some SFP modules, the send and receive (TX and RX) markings might be shown by arrows that show the
direction of the connection.
Step 3 If the SFP module has a bale-clasp latch, move it to the open, unlocked position.
Step 4 Align the module in front of the slot opening, and push until you feel the connector snap into place.
Figure 25: Installing an SFP Module in the Network Module
Step 5 If the module has a bale-clasp latch, close it to lock the SFP module in place.
Step 6
Remove the SFP dust plugs and save.
Step 7 Connect the SFP cables.
Figure 26: Network Module with SFP Modules Installed
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
50
Installing a Network Module