Stackpower Cabling Configurations - Cisco Catalyst 9300 Series Hardware Installation Manual

StackPower Cabling Configurations

StackPower Cabling Configurations

This section describes the recommended cabling configurations for a StackPower stack. There are two types
of StackPower cables.
The cable in the figure connects a switch to another switch in a power stack or with an XPS. StackPower
cables have color bands on the cable ends:
• The cable end with the green band can connect only to a switch.
• The cable end with the yellow band can connect to a switch or an XPS.
The cable is available in two lengths.
Part Number
CAB-SPWR-30CM
CAB-SPWR-150CM
Figure 15: StackPower Cable for Use with Cisco Catalyst 9300 Series Switches
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
28
Cable Type
StackPower Cable
StackPower Cable
Switch Installation
Length
0.3 meter
1.5 meter