Port Leds And Modes - Cisco Catalyst 9300 Series Hardware Installation Manual

LEDs
Color
Amber
Blinking amber

Port LEDs and Modes

Each Ethernet port, 1-Gigabit Ethernet module slot, and 10-Gigabit Ethernet module slot has a port LED.
These port LEDs, as a group or individually, display information about the switch and about the individual
ports. The port mode determines the type of information shown by the port LEDs.
To select or change a mode, press the Mode button until the desired mode is highlighted. When you change
port modes, the meanings of the port LED colors also change.
When you press the Mode button on any switch in the switch stack, all the stack switches change to show the
same selected mode. For example, if you press the Mode button on the active switch to show the SPEED
LED, all the other switches in the stack also show the SPEED LED.
Table 9: Port Mode LEDs
Mode LED
STAT
SPEED
DUPLX
ACTV
STACK
2
PoE
2 Only switches with PoE+ ports.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
10
Description
There is a fault: load shedding is occurring, a StackPower cable is defective, or
an administrative action is required. See the switch software configuration guide
for information about configuring StackPower.
The StackPower budget is not sufficient to meet current power demands.
Port Mode Description
Port status The port status. This is the default mode.
Port speed The port operating speed: 10, 100, or 1000 Mb/s.
Port duplex mode The port duplex mode: full duplex or half duplex.
Active The active switch status.
Stack member status Stack member status.
StackWise port status The StackWise port status. See
8.
The PoE+ port status. The PoE+ port status.
Product Overview
STACK LED, on page