Nat - TP-Link TD854W User Manual

Error! AutoText entry not defined.

RIP: Select to enable the RIP function or not. Click the Apply button to save your
configuration.
 Interface: Select the interface on which you want to enable RIP.

Recv Version: Indicate the RIP version in which information must be passed to the device. It
can be accepted into its routing table.

Send Version: Indicate the RIP version this interface will use when it sends its route
information to the other device.
Click the Add button to add a RIP configuration to the Rip Config List. Click the Delete button to
delete it.
The RIP Config List shows the current RIP setting of the device.

Note:
After adding a new entry, a Save button will appear on the left panel. You need to click the Save
button to make your changes take effect.

4.3.2 NAT

4.3.2.1 DMZ
Choose "Advanced→NAT→DMZ", you can configure the DMZ host in the screen as shown in
Figure 4-27.
A DMZ (demilitarized zone) is a host between a private local network and the outside public
network. It allows a single host on your LAN to expose all of its ports to the Internet. Users of the
public network outside the company can access to the DMZ host.
Error! AutoText entry not defined. User Guide
Figure 4-26
46