Table of Contents
Advertisement
Trunk Settings
Trunk Settings
Parameter
Description
Programming
Options
Parameter
Description
Programming
Options
4-28
Trunk Type
Determines whether the trunk circuit is an analog loop start, analog
ground start, analog DID, T1, CID, or ISDN.
Note:
For changes to this parameter to take effect, the system
must be powered down, then back up again.
FF2 (1-64)# 21# (0-5)#
0= Loop start
1=Ground start
2=DID
3=T1
4=CID
5=ISDN
ISDN Data Reset
Resets the ISDN settings stored in SRAM (Static Random Access
Memory). The reset restores these settings to default values.
FF1 9# 1# (0-1)#
Note: If you enter a "1," the following display appears:
CONFIRM
0: NO 1: YES
The purpose of this display is to make sure you want to reset the
data. Enter a 0 or 1, depending on whether you want to complete
or cancel the reset.
0=Do not reset
1=Reset
0=No (retain settings)
1=Yes (clear settings)
DBS-EX23-530
Programming Reference
Revised April 2000
Advertisement
Table of Contents
