Table of Contents
Advertisement
Quick-Start Programming
Slave Cabinet Set-Up
Note:Refer to "Typical Central Office Configurations" on page 3-10 for
setting below options. Default setting are In BOLD
Special Installation for adding second cabinet. If you are adding a second
cabinet (slave) to an existing installation that has a Primary Rate span
configured, you must re-enter the configuration settings for the ISDN
channels in the Master cabinet. The re-dimensioning of the system to the new
double cabinet (master/slave) configuration causes the address of FF1 9# 4#
4# 1# 2# (0-23) to be reset to the default value of zero (0).
9. Set up slave span:
Revised April 2000
FF1 9# 4# 4# 5# 5# (0-1)# ISDN International Dial Code
Address
Deduction
Options
0-Send as is
1-Deduct 011 from the code
FF1 9# 4# 4# 5# 6# (0-1)# ISDN Long Distance
Address
Code"1"Deduction
Options
0-Send as is
1-Deduct "1" from the code
Address
FF1 9# 4# 4# 5# 7# (0-1)# ISDN Type and Plan Option
Options
0-Determine Type and Plan
1-Always Type and Plan set to Unknown/Unknown
FF1 9# 4# 5# 5# 1# (0-1)# Network Type
Address
0-Public
Options
1-Private
Address
FF1 9# 4# 5# 5# 2# (0-1)# Auto Progress
Options
0-Disable
1-Enable
DBS-EX23-530
Programming Initial ISDN Options
3-7
Advertisement
Table of Contents
