Panasonic T-SMART DBS-EX23-530 Reference Manual page 103

5. After the DBS responds, type P and then press Enter.
6. Follow the directions on the screen to access the desired program. (See
Terminal Programming Through DISA
Note: The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1. Dial into the DBS through a DISA trunk.
2. Once you are connected, type #6 followed by the private password from
3. After the DBS responds with REMT>, type P and then press Enter.
4. Follow the directions on the screen to access the desired program. (See
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and an RAI card to
allow terminal programming using this method.
SPECIAL NOTICE: If you use the following method, the private password
must be given to the attendant. Use the new RAI access method instead. (See
"Additional RAI Access Method")
When programming through a normal trunk, perform the following steps:
1. Dial into the DBS through a normal trunk.
2. Ask the operator to place you on hold and dial #6 followed by the private
3. After the DBS responds with REMT>, type P and then press Enter.
4. Follow the directions on the screen to access the desired program. (See
DBS-2.3-400
#99xxxx (where xxxx = the site's private password)
"Terminal Programming Commands.")
your terminal communications program.
"Terminal Programming Commands.")
password to transfer you into remote programming.
"Terminal Programming Commands.")
DBS Manual - Revised April 2000 Page A-13