Displaying The Battery Charge; Changing The Batteries In The Cordless Telephone - Philips PPF 695 User Manual

3 Open the scanner cover and the cover of the automatic
document cover by first pushing the support (A) and
then the support (B) inside. The cover (C) folds below.
4 Lightly wipe the upper side of the scanner glass (A) and
the lower side of the document feeder/scanner film (=
white plastic plate) (B) with a cloth.
5 Clean the feed roller (A) and the underside of the sup-
port pad of the feeder roller (B) with a soft, lint-free
cloth moistened with cleaning alcohol (96 percent).
Rotate the feed roller; You must clean the entire roller.
6 Close the scanner cover and the cover of the automatic
document feeder. Both the supports must securely snap
into place.
Service
7 Turn the blue gear wheel forward to tension the ink
film. The ink film must not have any creases.
8 Close the device. Insert the paper tray in the opening
provided for it behind the paper feeder. Insert paper
again.

Displaying the battery charge

The charge indicator on the display shows the charge level
of the battery. If the charge is too low, the display illumi-
nation is switched off and the hands-free function is not
available. Place the cordless telephone into the charging
station.
Changing the batteries in the
cordless telephone
1 Press and hold ' (at least two seconds) for switching
off the cordless telephone.
2 Open the battery compartment on the backside of the
cordless telephone by pulling the cover down.
3 Remove the old batteries.
The batteries used should be disposed of accord-
ing to the recycling regulations of your country.
4 Insert the new batteries in the battery compartment
with the positive and negative poles as shown in the pic-
ture in the battery compartment.
EN
49