Power And Data Cabling Requirements; Ac Power - Philips VARILITE VL1100 LED User Manual

❋
VARI LITE® - VL1100 LED

Power and Data Cabling Requirements

AC Power

WARNING: Other than described herein, do not power a VL1100 LED™ Luminaire from a dimmed
circuit - even in "Non-Dim" mode. Dimmer and non-dim modules are not suitable sources of power
because their output modifies the AC wave form. This may work for a short time, but will eventually
result in power problems, luminaire mis-operation and/or failure. Using a dimmer or non-dim module
to power your VARI❋LITE® luminaire will void your luminaire's warranty.
The luminaire requires standard AC power distribution from 90-264 VAC, 50/60 Hz in order to power
all internal electronics and motors. It is equipped with a 3-pole Neutrik® PowerCon® locking
connector (with contacts for line, neutral, and premating safety grounds) for the purpose of AC
input.The mating Neutrik® powerCON TRUE1 connector is supplied, however, you will need to
purchase or construct a cable appropriate for your application.
Neutrik
Connector (supplied)
Current vs. Voltage
"VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)" on page 12
luminaire's current draw at specific voltages. Total Luminaire Current is calculated with the lamp on
and all motors sequencing.
WARNING: It is the responsibility of the user to adequately protect supply source with a correct size
and type circuit breaker and not overload circuits. AVERTISSEMENT: Il est de la responsibilité de
l'utilisateur de protéger adéquatement la source d'alimentation avec une taille correcte et le disjoncteur
de type et surchargez pas les circuits.
Table 2-1: VL1100 LED Luminaire - Current vs. Voltage (460W LED Source)
12
VL1100 LED HP U
AND
®
powerCON TRUE1
Figure 2-1: Power Connector
AC Voltage @ 60Hz
100V
110V
13 J un e 20 17
' M
SER S ANUAL
Total Luminaire Current (Motor + LED Current)
6.3A
5.7A
®
3-Pole Neutrik
Locking Connector
for AC input
provides the
02.1602.0002